2006 E85 E86 BMW Z4 N52 Engine Longblock 3.0i 3.0si. Will fit any 2006-2008 BMW Z4 equipped with the 3.0l N52 engine. Will not work for M models though, due to the engine differences. From a well maintained 2006 BMW Z4 3.0i that had 101k miles and a 6 speed manual transmission. This will fit an automatic transmission as well, however there may be some differences in the accessory components, wiring, and engine sensors that you would need to transfer over from your existing engine. Please do your research beforehand if planning on installing on an automatic car so that you are aware of the installation specifics. The motor was fully tested and in very good running condition with no smoke or hesitations. The engine idled smoothly at 900rpm and was able to be tested through all gears. The engine did have some leaks and oil residue from the valve cover gasket, front main seal, and rear main seal. We suggest replacing all of these gaskets. As well as performing any other manufacturer recommended maintenance at this mileage prior to installation of the engine. This engine was removed from a vehicle involved in a front end collision, which caused some light cosmetic damage to the harmonic balancer and oil cooler assembly on the front of the engine. The oil cooler has been removed, so you will need to install a new cooler / oil line. The rubber on the harmonic balancer does have some slight cracking and tears as shown. We suggest reusing your existing balancer for installation. The lower oil pan has some cosmetic wear and paint chipping as shown, however this did not cause any leaks or damage to the internals of the pan. Includes everything in the pictures, nothing more, nothing less: Engine cover, motor mount brackets, fuel rail, injectors, coils, intake manifold, throttle body, water pump, alternator, starter, and wiring harness. Does not include other accessories, or exhaust manifold. You will need to reuse your existing components and hardware for installation.
** This engine was removed from a 2006 Z4 3.0i with a production date of 06/2006. This engine will be a direct replacement for any 3.0i model with a production date between 03/2006 and 09/2006. This may still fit other later 2007-2008 models; however the PCV / emission system, valve cover, and engine covers were changed and you may need to transfer over those from your existing engine.**
2006 BMW E85 E86 Z4 3.0i (03/2006-09/2006 production dates)
****Please Read- Shipping Details Below****
This item will ship on a pallet via Fedex Freight to the Continental 48 States, Mexico and Canada. Please add the item to the cart to see the exact shipping costs associated with it. There will be two options for shipping, one without a liftgate equipped truck and one with a liftgate. If you have a business address with a loading dock, forklift or other means of unloading the pallet off of the delivery truck you will not need a liftgate equipped truck for delivery. If you have a residential address or are unsure about unloading the pallet from the truck please refer to the weight of the shipment above on this listing page, so you can make the decision on whether you will need a liftgate or not. For residential deliveries Fedex will contact you, at the phone number provided, to schedule an appointment for delivery. As with all freight companies they deliver to the curb, not inside, so please plan accordingly for your delivery.
This engine comes with a 90 day warranty that begins on the day the engine is received by the buyer. The warranty covers the engine block, crankshaft, pistons, rods, bearings, oil pump, cylinder head, head gasket, camshafts, valves and lifters against any defects that prevent the engine from operating as intended from the factory or make noises consistent with damaged engine internals ( rod knock, spun bearings, etc). Every engine we list on eBay has been fully run tested, compression tested and when possible test driven to make sure it runs smoothly, makes no odd noises and does not overheat.
What is not included in the warranty is common wear and tear items such as: timing belt, water pump, thermostat, spark plugs, spark plug wires, sensors and seals. While these items were in working condition at the time of testing, their lifespan is usually shorter than the internals of the engine and are therefore not covered under warranty. If any seals or gaskets are leaking at the time the engine is being tested and removed, or any sensors broken or defective, they will be noted in the item description. No labor, diagnostic or towing costs will be covered under warranty. In the event of a warranty claim, please be prepared to supply pictures, video and/or a statement from a shop/mechanic to validate the claim. This warranty is non-transferrable. It is only applicable to the original purchaser.
Situations that will void the warranty:
Overheating of the engine. We install "heat indicator tabs" on every engine prior to shipping that show when an engine has being operated at a temperature significantly higher than normal operating temperature. If these tabs show signs of overheating, the warranty will be void. If the engine in your car is being replaced due to damage from an overheating condition please locate and fix the source of the issue prior to running your new engine.
Not running fresh oil and oil filter in the engine (these engines ship drained of all oil).
Installation of an aftermarket turbocharger, supercharger or Nitrous Oxide kit.