2000-2005 Toyota Mr2 Spyder Engine Longblock. From a fully running 2004 Mr2 that had 196k miles. We were able to fully test and drive the motor and it was in very good running condition. Vehicle had a smooth idle with no smoking issues. Compression tested with good results (190-185-190-190). This was removed from a vehicle with the 6 speed SMT transmission, however it can be used for a manual transmission equipped vehicle as well. We noticed some oil seeping from the valve cover gasket during testing. It is recommended to replace these seals, as well as perform any general maintenance that is easier while the engine is removed from the vehicle. There is some typical surface rust and corrosion as shown. Some of the exhaust manifold studs did come loose during removal and will need to be replaced prior to installation. The plastic clips used to mount the engine cover broken off inside the valve cover. If you wish to install the factory plastic engine cover, you will need to extract these plastic remnants to do so. Includes everything in the pictures, nothing more, nothing less: Intake manifold, engine cover, AC compressor, fuel rail, alternator, and injectors. You will need to reuse some of your existing hardware and components for installation.
2000, 2001, 2002, 2003, 2004, 2005 Toyota Mr2 Spyder
Sales tax applicable within the state of Florida, automatically added at checkout for Florida residents.
****Please Read- Shipping Details Below****
This item will ship on a pallet via Fedex Freight to the Continental 48 States, Mexico and Canada. Please add the item to the cart to see the exact shipping costs associated with it. There will be two options for shipping, one without a liftgate equipped truck and one with a liftgate. If you have a business address with a loading dock, forklift or other means of unloading the pallet off of the delivery truck you will not need a liftgate equipped truck for delivery. If you have a residential address or are unsure about unloading the pallet from the truck please refer to the weight of the shipment above on this listing page, so you can make the decision on whether you will need a liftgate or not. For residential deliveries Fedex will contact you, at the phone number provided, to schedule an appointment for delivery. As with all freight companies they deliver to the curb, not inside, so please plan accordingly for your delivery.
This engine comes with a 90 day warranty that begins on the day the engine is received by the buyer. The warranty covers the engine block, crankshaft, pistons, rods, bearings, oil pump, cylinder head, head gasket, camshafts, valves and lifters against any defects that prevent the engine from operating as intended from the factory or make noises consistent with damaged engine internals ( rod knock, spun bearings, etc). Every engine we list on eBay has been fully run tested, compression tested and when possible test driven to make sure it runs smoothly, makes no odd noises and does not overheat.
What is not included in the warranty is common wear and tear items such as: timing belt, water pump, thermostat, spark plugs, spark plug wires, sensors and seals. While these items were in working condition at the time of testing, their lifespan is usually shorter than the internals of the engine and are therefore not covered under warranty. If any seals or gaskets are leaking at the time the engine is being tested and removed, or any sensors broken or defective, they will be noted in the item description. No labor, diagnostic or towing costs will be covered under warranty. In the event of a warranty claim, please be prepared to supply pictures, video and/or a statement from a shop/mechanic to validate the claim.
Situations that will void the warranty:
Overheating of the engine. We install "heat indicator tabs" on every engine prior to shipping that show when an engine has being operated at a temperature significantly higher than normal operating temperature. If these tabs show signs of overheating, the warranty will be void. If the engine in your car is being replaced due to damage from an overheating condition please locate and fix the source of the issue prior to running your new engine.
Not running fresh oil and oil filter in the engine (these engines ship drained of all oil).
Installation of an aftermarket turbocharger, supercharger or Nitrous Oxide kit.